Need metal roof installation in Lancaster? We come look first, tell you plainly what it needs, and put the price in writing before anything starts.
A metal roof is what Roofing Brothers is known for, and it has been since 2002. On a Lancaster home that means standing seam or exposed fastener panels set over sound decking and real underlayment, with the ridge, valley and eave trim cut and fit on site rather than forced out of a box.
Not every Lancaster roof needs the biggest job on the sheet. When we quote metal roof installation we tell you honestly whether a repair will hold, whether doing one section will do, or whether you are genuinely past that — and we would rather do the smaller job well.
Metal is our specialty, so if metal roof installation on your Lancaster home opens the door to standing seam or a panel roof, we will price that right alongside the shingle option and let you compare the real numbers side by side.
Four steps and no surprises. This is how we have done it since 2002.
Nothing gets ordered until you have a written price in hand and have settled on the color you actually want.
Where the decking is sound and there is only one layer, we can often go over the top on purlins. We tell you which one your house calls for.
Synthetic underlayment over the whole roof, ice and water shield in the valleys and at the eaves, then panels set square on the correct fastener spacing.
Then the yard gets picked up, the scrap gets hauled off, and a magnet goes over the drive before we pull out.
The things people want to know before they tell us to go ahead.
Most Lancaster metal roof jobs land between about $12,000 and $30,000 in 2026, depending on square footage, pitch, panel type and how much tear off is involved. Standing seam runs higher than exposed fastener panels. We measure before we quote and the estimate is free.
Much less than people expect. Over solid decking with underlayment, a Lancaster metal roof sounds about like a shingle roof from inside. The loud tin roof people remember was screwed to open purlins on a barn.
Around twenty standard colors. Green, burgundy, bronze, black, gray, tan and barn red are the ones most Lancaster homeowners land on. We bring the chart with the estimate so you can hold it against your siding.
A straightforward Lancaster house is usually three to five days. A cut up roof with dormers, valleys and multiple pitches takes longer, because every panel and trim piece gets measured and fit on site.
Real feedback from homeowners we have worked for.
"Burgundy metal roof on our brick ranch and I get compliments on it constantly. They brought the color chart out and let us take our time deciding."
"They replaced the soffit and fascia the squirrels had chewed through and closed everything back up tight. No more scratching in the attic at night."
"Tore off two layers of old shingles and found rotten decking underneath. They showed me the boards, told me what the change would cost, and let me decide before going ahead."